Misc parts wanted list

[gclauson]

I am building a 1966 beater into a trail rig. I'm looking for these parts- they don't need to be perfect, some dents or rust is probably okay.

Upper coil spring retainer clips
Lower coil spring cups
Leaf spring shackles
Lower center firewall sheet metal (angles between vertical firewall and top of transmission tunnel)

1966-67 doors and/or door parts
1966-68 grille (small turn signals), headlight buckets, trim rings, etc
Tailgate latch handle assy
License plate bracket assy
1966 steering column dash surround (metal and the rubber part)
1966 ashtray
Steering column support bracket that attaches to firewall with 3 bolts and the column clamps to it

Perhaps someone has these takeoffs in a junk pile and will unload them cheap or free? Just need to make a rolling chassis until I get "real" axles
- Dana 30 hubs, spindles, drums, axle shafts, drive flanges or lockout hubs
- Ford 9" 28 spline standard axles (preferably with big bearing retainers)

Call or text at 303-578-8432
Gary

[Kinder]

I probably have the 9” axles, and possibly some other small parts, I’ll look in storage.

[phyler]

I have some lower spring cups.

Sent from my Pixel 5 using Tapatalk

[Justin]

I've got a few axles. Not sure about the retainer size. They're rusty, but you can have them.

[Friday]

I probably have these. I can check in my parts pile.
Tailgate latch handle assy
License plate bracket assy

[gclauson]

Thanks to everyone- I believe I have PM replied.

I could also use a set of 4 steel wheels with tires that hold air. Don't need to be OEM Ford, but more narrow/stockish width (5-6") and smaller tire size (<31 x 9" or so).

Gary

[gclauson]

Updating the list for what I am still looking for:

Leaf spring shackles
Lower center firewall sheet metal (angles between vertical firewall and top of transmission tunnel)

1966-67 doors and/or door parts
1966-68 grille (small turn signals), headlight buckets, trim rings, etc
Tailgate latch handle assy
License plate bracket assy
1966 steering column dash surround (metal and the rubber part)
1966 ashtray

Perhaps someone has these takeoffs in a junk pile and will unload them cheap or free?
- Dana 30 hubs, spindles, drums, axle shafts, drive flanges or lockout hubs

Thanks!

[BOBS 2 68S]

I have the most of the Dana 30 parts from a disk brake conversion. I don't have any 30 axles.

[mickphatmac]

Thanks to everyone- I believe I have PM replied.

I could also use a set of 4 steel wheels with tires that hold air. Don't need to be OEM Ford, but more narrow/stockish width (5-6") and smaller tire size (<31 x 9" or so).

Gary

4 steelies $100 bucks but no tires

[Kinder]

I have a license plate bracket assembly, I even know where it’s at in storage.