|
It is currently Mon Nov 25, 2024 8:30 pm |
|
All times are UTC - 7 hours [ DST ] |
|
Page 1 of 1 |
[ 5 posts ] |
| Previous topic | Next topic |
ZF trans over haul
| Author | Message |
|---|---|
|
Official CCB Member  Joined: Mon Jan 21, 2013 8:24 pm Posts: 408 Location: Grand Junction CO 
|
 ZF trans over haulHey guys I was wondering if any of you guys have experience with rebuilding the ZF 5 speed & how difficult are they to do.
|
| Mon Sep 18, 2017 7:40 pm |
 
|
|
|
|
Official CCB Member Joined: Sat Oct 02, 2010 9:41 pm Posts: 1201 Location: Erie
|
Re: ZF trans over haul _________________ 1975 Ranger Edition that I've had longer than I've been without it. |
| Mon Sep 18, 2017 8:48 pm |
|
|
|
|
Official CCB Member  Joined: Fri Jun 21, 2013 8:53 pm Posts: 1276
|
Re: ZF trans over haul It's not a hard transmission to work on, in fact I found the layout to be very serviceable.
That said, a full rebuild takes a handful of special tools. Here is a good online tutorial: There are .pdf's online of the S5-42 / 47 service manual. I would suggest grabbing a copy and read through it to understand the scope of the job. I haven't tore mine all the way down, but far enough to replace some bad bearing and seals. _________________ Cummins R2.8 diesel, ZF5, AtlasII, HP44/BB9, ARBs, coiled / linked suspension, 37" KO2s, full cage, bumpers, etc. Build Thread: Average 23.5 mpg, Best tank: 25.1 mpg |
| Mon Sep 18, 2017 9:45 pm |
|
|
|
|
Official CCB Member  Joined: Thu Nov 11, 2010 10:36 am Posts: 5984 Location: California
|
Re: ZF trans over haul Mine was easy! Pulled it, dropped it off at a shop and picked it up a week later! For me it just made good sense to do this and I found a great shop that did it for a reasonable price.
_________________ 1973 Bronco, 351 SEFI, Locked, discs, 35's ZF-5spd and Atlas 4spd. 235:1 Crawl Ratio. It may be ugly, but it's slow. http://www.ucora.org |
| Tue Sep 19, 2017 9:28 am |
|
|
|
|
Official CCB Member Joined: Mon Jan 21, 2013 8:24 pm Posts: 408 Location: Grand Junction CO
|
Re: ZF trans over haul Thanks Digger that's a good start I will do more to educate myself on the process. I think I have all the pullers required.
|
| Tue Sep 19, 2017 6:36 pm |
|
|
|
|
|
Page 1 of 1 |
[ 5 posts ] |
|
All times are UTC - 7 hours [ DST ] |
Who is online |
Users browsing this forum: No registered users and 78 guests |
| You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot post attachments in this forum |