Looking for tailgate hardware. Bottom pivots, latches, handle, rods. Etc. condition does not matter.

Windshield frame. Ugly is good. Rust is not a problem.

Old nasty body panels. Planning some rust repair in the future? Good. I want the junk you cut out. Chunks of door posts and striker latches are good. So are rocker panels. Floor boards and support channels.

Basically I'm looking to build the Project X tub out into the ugliest Frankenstein looking Bronco possible.

Again, not looking for anything worth more than scrap value. Only dumpster bound parts.

Also looking for a passenger side kick panel. I don't want to keep it, only borrow it to use as a template. I have a sheet of steel at the house and access to a plasma table so I'm looking to make a new kick panel rather than buying one. Prefer new for this.

There are some bends in the kick panel to correct line up the door post with the other body lines. Probably not hard to reproduce them.

Cool. Give me a heads up a few hours in advance and I can meet ya up there. I can haul my sheet metal up and draw my template same day so I don't need to hang on to it.

I know the in all the stuff I gave Mike with the 74 there was tailgate hardware that came off Chad's bronco.

I have the pivots, spare carrier latch and the backing plate for the latch. maybe a few other things.

They have a TV show about this.

http://en.m.wikipedia.org/wiki/Hoarders

The difference between me and a hoarder is I am actually going to start assembling a Bronco out of this stuff soon.

Wait. Hoarders say that too, don't they.

Want?

Surprisingly, I am good on those two pieces so I'll pass.

Thank you though!

I have a driver's door, spare tire carrier with slight bend, tire carrier brackets and latch.

All free if you're interested. I can get pictures.

I could use the brackets and latch. Let me check my beater doors for condition.

I may have a windshield frame.

Is it ugly? Rusty? Crooked?

Rusty, yes. Especially the bottom. Crooked? I don't think so. I could throw it up and down the alley a few times if that helps.

I don't want you to put yourself out too much so I'll settle for rusty.

Barring any unforeseen events, I will be in Denver on the 19th and 20th.

I'll be around on the 19th or 20th, after work, of course. Usually home by 4:30.

Update: I have a kick panel now. I'll also be headed north tomorrow and Sunday and can pick up stuff.

Sorry I missed your last message. I'll be around all day Saturday (the 13th) if you want to stop by.

Need to add some parts on to this. I have the large slotted bracket and of the two identical brackets. Need everything else.

I might have those AND can find them.