|
It is currently Mon Nov 25, 2024 10:15 pm |
|
All times are UTC - 7 hours [ DST ] |
|
Page 1 of 1 |
[ 7 posts ] |
| Previous topic | Next topic |
Explorer EFI Heater Pipes
| Author | Message |
|---|---|
|
Official CCB Member  Joined: Thu Jun 07, 2012 10:10 pm Posts: 94 Location: Pueblo West, CO 
|
 Explorer EFI Heater PipesI need to two pipe assembly that goes from the manifold back to the rear of the engine. If you have one or know of a 5.0L explorer at a pick and pull that I can get those off of, I'd be much obliged.
_________________ 1966 Bronco (Aug. 1965 production date), 5.0L Explorer EFI, 33x12.50 BFG AT |
| Tue Jul 17, 2012 7:33 pm |
  
|
|
|
|
Official CCB Member  Joined: Wed Oct 27, 2010 6:25 pm Posts: 4901 Images: 0 Location: Colorado Springs
|
Re: Explorer EFI Heater Pipes High tail it up to COS and hit the UPullandPay. Last I was there, 3-5 Exploders in the yard. All with 5.0s. I can try and swing by tomorrow during lunch to confirm for you. Save you the drive if they are not there.
_________________ Stroppe'd 1972 Sport, 302, 3 speed with old school Duff floor shifter, T shift Dana 20 with JB Fab twin stick, 4.11 gears with Trac-loc, Lincoln hydroboost, Chevy disc conversion, WH gas lift gate shock kit, 33" Duratrac tires on slots and about 2.5" of lift, Stroppe installed: bumper braces, dual shocks on all four corners, GM power steering, trans cooler mount, auto shift column, rollbar. The Terrible One 1972 Sport uncut, 302, C4 with 1974 column , T shift Dana 20, 3.50 gears w/ limited slip, 1966 U13 Roadster kick panel, and factory power steering. 1973 Stroppe Baja project |
| Tue Jul 17, 2012 8:15 pm |
|
|
|
|
Official CCB Member Joined: Thu Jun 07, 2012 10:10 pm Posts: 94 Location: Pueblo West, CO
|
Re: Explorer EFI Heater Pipes I would very much appreciate that. If they've got one with the heater pipe intact, I'll drive up tomorrow and get it.
I'll PM you my cell number and email, you can use either. _________________ 1966 Bronco (Aug. 1965 production date), 5.0L Explorer EFI, 33x12.50 BFG AT |
| Tue Jul 17, 2012 8:39 pm |
|
|
|
|
Official CCB Member Joined: Wed Oct 27, 2010 6:25 pm Posts: 4901 Images: 0 Location: Colorado Springs
|
Re: Explorer EFI Heater Pipes I've got good news and bad news.
Bad news: I'm not going to the yard tomorrow. Good news: I'm not going because I just remembered I have a GT40/Explorer lower intake in the garage with those pipes on it. I'll get with you via the contact info you sent to get them too you. _________________ Stroppe'd 1972 Sport, 302, 3 speed with old school Duff floor shifter, T shift Dana 20 with JB Fab twin stick, 4.11 gears with Trac-loc, Lincoln hydroboost, Chevy disc conversion, WH gas lift gate shock kit, 33" Duratrac tires on slots and about 2.5" of lift, Stroppe installed: bumper braces, dual shocks on all four corners, GM power steering, trans cooler mount, auto shift column, rollbar. The Terrible One 1972 Sport uncut, 302, C4 with 1974 column , T shift Dana 20, 3.50 gears w/ limited slip, 1966 U13 Roadster kick panel, and factory power steering. 1973 Stroppe Baja project |
| Tue Jul 17, 2012 8:48 pm |
|
|
|
|
Official CCB Member Joined: Thu Jun 07, 2012 10:10 pm Posts: 94 Location: Pueblo West, CO
|
Re: Explorer EFI Heater Pipes No longer needed thanks to akaFrankCastle. Thanks for the pipes and nice meeting you (and the little lady).
_________________ 1966 Bronco (Aug. 1965 production date), 5.0L Explorer EFI, 33x12.50 BFG AT Last edited by jbregar on Sat Jul 21, 2012 9:19 pm, edited 1 time in total. |
| Fri Jul 20, 2012 1:04 pm |
|
|
|
|
Official CCB Member Joined: Wed Oct 27, 2010 6:25 pm Posts: 4901 Images: 0 Location: Colorado Springs
|
Re: Explorer EFI Heater Pipes No worries brother. Hope you enjoyed the ballgame. And maybe one day SHE will be driving the Bronco.
 _________________ Stroppe'd 1972 Sport, 302, 3 speed with old school Duff floor shifter, T shift Dana 20 with JB Fab twin stick, 4.11 gears with Trac-loc, Lincoln hydroboost, Chevy disc conversion, WH gas lift gate shock kit, 33" Duratrac tires on slots and about 2.5" of lift, Stroppe installed: bumper braces, dual shocks on all four corners, GM power steering, trans cooler mount, auto shift column, rollbar. The Terrible One 1972 Sport uncut, 302, C4 with 1974 column , T shift Dana 20, 3.50 gears w/ limited slip, 1966 U13 Roadster kick panel, and factory power steering. 1973 Stroppe Baja project |
| Fri Jul 20, 2012 9:31 pm |
|
|
|
|
Official CCB Member Joined: Thu Jun 07, 2012 10:10 pm Posts: 94 Location: Pueblo West, CO
|
Re: Explorer EFI Heater Pipes Ugh, my bad. Sorry about that. Corrected. :)
_________________ 1966 Bronco (Aug. 1965 production date), 5.0L Explorer EFI, 33x12.50 BFG AT |
| Sat Jul 21, 2012 9:20 pm |
|
|
|
|
|
Page 1 of 1 |
[ 7 posts ] |
|
All times are UTC - 7 hours [ DST ] |
Who is online |
Users browsing this forum: No registered users and 17 guests |
| You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot post attachments in this forum |