|
|
It is currently Tue Nov 26, 2024 12:39 am
|
|
Page 1 of 1
|
[ 5 posts ] |
|
| Author |
Message |
|
Gunnibronco
Official CCB Member
Joined: Mon Jan 03, 2011 6:07 pm
Posts: 4074
Location: Gardnerville, NV
|
 What did I just see? I was looking at a junked out dent side 4x4 Ford Econoline.
I saw it had radius arms and was high pinon, and thought I might grab it (free). The radius arm wedges were separate from the knuckles (pre 78 style). Then I noticed it had king pins, not ball joints. Was it a 44 or a 30? Never seen anything like it.
Looked like a D20 and a 9". I was told I could take anything off it I wanted. Would it have a C4 or a C6?
_________________
"America is at that awkward stage. It's too late to work within the system, but too early to shoot the bastards." – Claire Wolfe
74-AWB 98", ZF5, Atlas4, TGW HP1060 and HP1014 axles, ARBs, 37's, 3.5" lift-5.5" front coil springs, Tahoe rear springs, EFI 302, h-boost, York OBA, 4x4x2, custom dash & gauges
72 U15- Explorer Sport-Candyapple Red (1 of 141)
|
| Thu May 12, 2016 5:13 pm |
|
|
|
sykanr0ng
Official CCB Member
Joined: Thu Jan 22, 2015 1:46 am
Posts: 405
Location: Greeley, CO
|
Re: What did I just see? They weren't made by Ford, so it could be built with just about anything.
_________________
"You say overkill like it's a bad thing."
|
| Fri May 13, 2016 2:00 am |
|
|
|
Gunnibronco
Official CCB Member
Joined: Mon Jan 03, 2011 6:07 pm
Posts: 4074
Location: Gardnerville, NV
|
Re: What did I just see? I found a little bit of info, but not much. Looks like there were kingpin HP D44s put into F100's from about 65-70. The pumpkin was weaker than a ball joint D44. The dent side van body style started in 75.
_________________
"America is at that awkward stage. It's too late to work within the system, but too early to shoot the bastards." – Claire Wolfe
74-AWB 98", ZF5, Atlas4, TGW HP1060 and HP1014 axles, ARBs, 37's, 3.5" lift-5.5" front coil springs, Tahoe rear springs, EFI 302, h-boost, York OBA, 4x4x2, custom dash & gauges
72 U15- Explorer Sport-Candyapple Red (1 of 141)
|
| Fri May 13, 2016 7:11 am |
|
|
|
ZOSO
Moderator
Joined: Mon Nov 15, 2010 5:58 pm
Posts: 3906
Location: Henderson, Co
|
Re: What did I just see? I believe they were also closed knuckle.
_________________
Rob
74 Ranger EFI351w, 4r70w, ARB 5.13 9in, ARB 5.13D44, and a bunch of other goodies. Best of all the family memories.
04 Mustang Cobra, KenneBell 2.2 feeding a lot of boost on E85. Tire shredding machine
New project: 77 Bronco Ranger, body work and more body work.
Very little left of a 72 durango tan explorer sport
|
| Fri May 13, 2016 7:38 am |
|
|
|
Gunnibronco
Official CCB Member
Joined: Mon Jan 03, 2011 6:07 pm
Posts: 4074
Location: Gardnerville, NV
|
Re: What did I just see? IDK, but what I saw yesterday was open knuckle.
_________________
"America is at that awkward stage. It's too late to work within the system, but too early to shoot the bastards." – Claire Wolfe
74-AWB 98", ZF5, Atlas4, TGW HP1060 and HP1014 axles, ARBs, 37's, 3.5" lift-5.5" front coil springs, Tahoe rear springs, EFI 302, h-boost, York OBA, 4x4x2, custom dash & gauges
72 U15- Explorer Sport-Candyapple Red (1 of 141)
|
| Fri May 13, 2016 7:42 am |
|
|
|
|
|
Page 1 of 1
|
[ 5 posts ] |
|
Who is online |
Users browsing this forum: No registered users and 75 guests |
|
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot post attachments in this forum
|
|
