I have a 74 bronco that I bought a few years ago. I started in to it to replace just floor plans and rocker panels. I was wishful thinking lots more rust then ever thought . The body was so rusty that body had sag around the front cab mounts bad enough that the door would not go back on and close, nor would the top go back on and bolt down. I took a ton of measurments but now with the complete new floors, kick panels,inner fendes from the grill back, front door pillars, complete rocker panels, transmission hump and floor support my measurements are all off. I welding in a grid to support everything befor cutting, not knowing the front floor support was bent and rusted away completely from the front door pillar. So does any one know were I can get measurements on door opening floor to dash stuff like that. I have been watch for one around town to stop and measure it but havent seen one yet. I was hoping for almost like a body blue print. I would have looked for a new tub if i would of known but i am in to far now and i do want to save it.

The attached has been posted on CB several times. Maybe this will help?