So I know it has been quite some time since I received my beard seats and I have been holding out on pics.
I have been working on the install over the last week or two as time permits.
I have the passenger mounted where I want it and just need to remove all the brackets to pretty them up.
For the driver I have made some mounts with sliders, they need some improvement on sliding as they bind, and even though I am short they ended up being a little too tall so they will need to be shortened.
I will be drilling holes at various locations to lock the seats into position and use some sort of hitch pin or something to make it easy to adjust, even though they will be in one spot 99.9% of the time.
The seats so far are very comfy.
Colors are charcoal center and black sides with a "carbon fiber" weave on the backs and sides that are vinyl( add some texture) and expanded steel pattern piping.
I will be finishing these out as time permits and like the passenger when they work right they will get pulled and ground and shaped pretty and painted black.
dont pick on my welds or lack of fab skillz
bronco seats 007.jpg
bronco seats 009.jpg
bronco seats 005.jpg
bronco seats 010.jpg
bronco seats 011.jpg
bronco seats 017.jpg
bronco seats 020.jpg