So I had built up a new engine from parts off of the original 75DBE engine and the donor motor. Before mating it up to the transmission and throwing it back in the Bronco, I wanted to make sure that it ran so I took it down to Steve Mills Racing -- the guy at American Speed, who I like, was just too busy. On Friday Steve called to tell me that the Torker II intake manifold -- which I had media blasted by a guy over on Airport Road I think -- was corroded on the inside and would not seal up with the block. Water leaked out everywhere. He also said that the metal on the manifold was so thin he could have
d a screw driver through it. Makes me mad that the guy that media blasted it didn't alert me since he had a stack of 30 manifolds sitting there! Grrr...I'll never go back! So long story short, he had another Torker II manifold sitting around that he threw on it and got the engine running today. He said there was no smoke -- yippee -- but that he could not get the crab adjusted very well, yet. Said it was way too lean. Anyone have any thoughts?