| www.ColoradoClassicBroncos.com http://coloradoclassicbroncos.com./ |
|
| Stock steering wheel -to- ‘79 column http://coloradoclassicbroncos.com./viewtopic.php?f=4&t=10461 |
Page 1 of 1 |
| Author: | mickphatmac [ Sat Aug 22, 2020 11:36 am ] |
| Post subject: | Stock steering wheel -to- ‘79 column |
Does anyone have any experience or thoughts on how I might clean this up a bit? Trying to adapt stock early bronco steering wheel to ‘79 tilt column. Do I just need to buy an adapter kit for a 78 to 91 Ford? (that’s how they are listed on eBay and other sites) Or is it gonna be more difficult than that? |
|
| Author: | Kinder [ Sat Aug 22, 2020 1:32 pm ] |
| Post subject: | Re: Stock steering wheel -to- ‘79 column |
That’s tricky, you may also have to trim some of the shroud back on the column to get the trim ring in there. |
|
| Author: | mickphatmac [ Tue Aug 25, 2020 8:57 pm ] |
| Post subject: | Re: Stock steering wheel -to- ‘79 column |
Ok, well after I totally dismantled, dismembered, and disfigured the rubber plastic from the ‘79 steering wheel trying to make the little ring on the very very bottom adapt to the stock steering wheel, I ended up going to Hobby lobby... yeah yuck it up, I went to Hobby lobby and I got some 1/8th inch black foam, some heavy duty double sided tape, and some black vinyl. I ended up using a cut off wheel and cut the very bottom of the metal neck off of the original steering wheel and used it as a spacer and cam canceler and then I used the foam to step up from the smaller diameter to larger and then I covered the foam with black vinyl. For the amount of time I spent on this piece of crap, that’s all I will notice but some of you other guys might not notice it at all!!! Lol!!! |
|
| Page 1 of 1 | All times are UTC - 7 hours [ DST ] |
| Powered by phpBB © 2000, 2002, 2005, 2007 phpBB Group http://www.phpbb.com/ |
|